Home | Aquarium Water Treatment | Phosphate Reducers | Kent Marine Phosphate Sponge |  Kent Marine Phosphate Sponge 2 Quart

Kent Marine Phosphate Sponge 2 Quart

Kent Marine Phosphate Sponge is a ceramic filtration medium which will adsorb phosphates and silicates quickly (within hours) when placed directly in the water flow. Kent Marine Phosphate Sponge can be used in fresh and saltwater aquariums or ponds. One quart of Kent Marine Phosphate Sponge will reduce water of approximately 1.0 ppm of phosphate or silicates down to less than 0.05 ppm in a 120 gallon tank. For silicates to be removed, phosphates must first be removed. The beads in Kent Marine Phosphate Sponge are designed as cracked to expose more surface area and increase efficiency. This product will not release any soluble aluminum compounds into your aquarium, causing negative reactions from your inverts, as competing products may. Kent Marine Phosphate Sponge will also absorb moisture for use as an air dryer for ozone. It is important to treat your water carefully when adding it to your aquarium, as many water companies add phosphates to the tap water to assist in controlling lead consumption by humans, and sodium silicate (water glass) is also added to help reduce pipe corrosion. Phosphates and silicates also naturally occur in rivers and lakes. Bead renewal: For phosphate removal, renewal may or may not be possible, depending on conditions of use. For product renewal spread 1/4" thick on a baking pan. Place in a 450 degree oven for one hour (do not use the pan for food). Let the beads cool. Rinse with fresh water (preferably reverse osmosis or deionized water) and re-use. These beads may be renewed up to twice, depending on circumstances of use; however, the capacity will be much lower each time. When reusing, leave for 8 hours, maximum. Directions: Rinse with fresh water (WARNING: PRODUCT MAY GET VERY HOT THE FIRST TIME IT IS WET!). Use rubber gloves and/or place in a plastic container while rinsing! Place in a large mesh bag (800 micron) or a canister filter, directly in the water flow. Make sure water flows through the material and not just around it. Leave for 8 hours to 2 days maximum (as with any phosphate absorber, phosphates can be re-released into the system if the initial charge is left in the system continuously. If you want to leave in the system to keep phosphates low or to remove silicates, replace initial charge with brand new beads and change on a regular basis.) For silicate removal, phosphate must first be removed, and then a new charge of Kent Marine Phosphate Sponge must be left in the system for several days. Price: £50.39 Quantity: (Delivery Information) Kent is usually ships same day or 1 - 5 working days but if out of stock can take up to 10 working days Kent Marine Phosphate Sponge 2 Quart Reviews